Fluid Capacities for a Dodge Sprinter Van
SPECIFICATIONS – FLUID CAPACITIES
T1N 2001 2002 2003 2004 2005 2006- Dodge Sprinter Van
ENGINE COOLANT Capacity
10 Liters 10.5 Quarts
ENGINE OIL
9.0L without Filter Replacement
9.5 Quarts with Filter Replacement
2006- Dodge Sprinter Van AUTOMATIC TRANSMISSION Capacity
Service Fill – NAG1 5.0 L (10.6 pts.)
O-haul Fill – NAG1 7.7 L (16.3 pts.)
Dry fill capacity Depending on type and size of internal cooler, length and inside diameter of cooler lines,
or use of an auxiliary cooler, these figures may vary.
(Refer to appropriate 21 – TRANSMISSION/AUTOMATIC/FLUID – STANDARD PROCEDURE).
REAR AXLE ±.03L (1 oz.)
8 1/2 1.8 L (4.0 pts.)
2006- Dodge Sprinter Van FUEL TANK Capacity
Primary 100 L (26.4 gal.)*
Reserve 10.5 L (2.8 gal.)*
*Nominal refill capacities are shown.
A variation may be observed from vehicle to vehicle due to manufacturing tolerance and refill procedure
Do not blend other specific fuel additives with diesel fuel. They only result in unnecessary cost, and
may be harmful to the engine operation.
POWER STEERING FLUID
No fluid service required. Filled with Power Steering Fluid approved to MB 236.3, such as Mobil
ATF-D (Exxon Mobil Corporation) or equivalent.
OPERATION – AUTOMATIC TRANSMISSION
FLUID
The automatic transmission fluid is selected based
upon several qualities. The fluid must provide a high
level of protection for the internal components by
providing a lubricating film between adjacent metal
components. The fluid must also be thermally stable
so that it can maintain a consistent viscosity through
a large temperature range. If the viscosity stays constant through the temperature range of operation,
transmission operation and shift feel will remain consistent. Transmission fluid must also be a good conductor of heat. The fluid must absorb heat from the
internal transmission components and transfer that
heat to the transmission case.
DESCRIPTION SPECIFICATION
POWER STEERING SYSTEM
Power steering fluid capacities are dependent on
engine/chassis options as well as steering gear/cooler options. Depending on type and size of internal
cooler, length and inside diameter of cooler lines, or
use of an auxiliary cooler, these capacities may vary.
Refer to 19, Steering for proper fill and bleed procedures.
FLUID FILL / CHECK LOCATIONS
INSPECTION – FLUID FILL / CHECK LOCATIONS
The fluid fill/check locations and lubrication points
are located in each applicable group.
HOISTING
STANDARD PROCEDURE – HOISTING
Refer to the Owner’s Manual for emergency vehicle
lifting procedures.
WARNING: THE HOISTING AND JACK LIFTING
POINTS PROVIDED ARE FOR A COMPLETE VEHICLE. WHEN A CHASSIS OR DRIVETRAIN COMPONENT IS REMOVED FROM A VEHICLE, THE
CENTER OF GRAVITY IS ALTERED MAKING SOME
HOISTING CONDITIONS UNSTABLE. PROPERLY
SUPPORT OR SECURE VEHICLE TO HOISTING
DEVICE WHEN THESE CONDITIONS EXIST.
FLOOR JACK
When properly positioned, a floor jack can be used
to lift a vehicle. Support the vehicle in the raised
position with jack stands at the front and rear ends
of the frame rails.
CAUTION: Do not lift vehicle with a floor jack positioned under:
• An axle tube.
• A body side sill.
• A steering linkage component.
• A drive shaft.
• The engine or transmission oil pan.
• The fuel tank.
• A front suspension arm.