How to Install Machined Face Wheels by VISION OFF-ROAD® on Your 2001-2006 Sprinter Van (Click for wheel specs and product purchase)

How to Install Machined Face Wheels by VISION OFF-ROAD® on Your 2001-2006 Sprinter Van

Enhancing the look and performance of your 2001-2006 Sprinter Van with Vision Off-Road Machined Face Wheels is easy when you follow these step-by-step instructions. Here’s everything you need to know to ensure a smooth and secure installation.

Tools and Materials Needed:

  • Floor jack and jack stands
  • Torque wrench
  • Lug wrench or socket wrench
  • Tire iron (if necessary)
  • Installation Kit (includes lug bolts) – provided with your purchase from T1NParts.com

Step 1: Prepare Your Vehicle

  1. Park on a Level Surface: Ensure your van is parked on a flat, stable surface. Engage the parking brake and block the wheels to prevent any movement.
  2. Loosen the Lug Nuts: Before lifting the van, use a lug wrench to slightly loosen the lug nuts on each wheel. Do not fully remove them yet.

Step 2: Lift the Van Safely

  1. Use a Floor Jack: Position the floor jack under the manufacturer’s recommended lift points (refer to your Sprinter’s manual).
  2. Lift and Support: Raise the vehicle and place jack stands securely under the chassis to support it. Double-check that the van is stable on the jack stands before proceeding.

Step 3: Remove the Old Wheels

  1. Fully Remove the Lug Nuts: Unscrew the lug nuts completely and carefully remove the existing wheels.
  2. Clean the Hub: Wipe down the wheel hub with a cloth to remove any dirt or rust, ensuring a smooth surface for the new wheels.

Step 4: Install the Vision Off-Road Wheels

  1. Position the New Wheel: Line up the new Vision Off-Road wheel with the bolt holes on the hub.
  2. Hand-Tighten the Lug Nuts: Thread each lug nut by hand to avoid cross-threading. Make sure they are snug but not fully tightened.

Step 5: Lower the Van and Torque the Lug Nuts

  1. Lower the Vehicle Slightly: Use the jack to lower the van just enough so that the new wheel touches the ground, but the full weight of the van is not on it.
  2. Torque the Lug Nuts: Using a torque wrench, tighten the lug nuts in a crisscross (star) pattern to ensure even tightening. Refer to your vehicle manual for the correct torque specification (typically around 100-130 lb-ft for Sprinter vans).
  3. Lower the Van Fully: Once the wheels are torqued, fully lower the van off the jack stands.

Step 6: Final Check

  1. Verify Torque: After driving for about 25-50 miles, recheck the torque on all lug nuts to ensure they are still properly tightened.
  2. Inspect the Installation: Confirm that all wheels are securely attached and there is no wobbling or unusual sounds when driving.

Important Tips:

  • Safety First: Always wear safety gear and ensure the van is stable on jack stands before working under or around it.
  • Use the Installation Kit: All necessary lug bolts are included with your wheels from T1NParts.com, ensuring compatibility and security.
  • Check for Clearance: After installation, turn the wheels to check for any rubbing or clearance issues, especially if your van is lifted or has custom components.

By following these instructions, you can enjoy your new Vision Off-Road Machined Face Wheels with confidence. These wheels not only enhance the look of your Sprinter van but are also designed for durability on any adventure. Enjoy the ride!