How to Clone a T1N 2002-2006 Sprinter Van Key Using the Vz8 Super Mini Zedbull Key Programmer

CLICK HERE TO THE PRODUCT PAGE TO PURCHASE A KEY CLONER

Click Here to Purchase a Transponder Key

This guide provides step-by-step instructions for using the V5z8 Super Mini Zedbull Key Programmer to clone a YM15Tf-SI transponder key, commonly used with automotive immobilizer systems.

o clone a YM15Tf-SI key using the V5z8 Super Mini Zedbull (Smart Zed-Bull Key Programmer), follow these general steps:

  1. Connect the V5z8 Zedbull: Connect your Zedbull device to a power source and, if using the software, connect it to your computer via USB.
  2. Insert the Original Key: Place the original YM15Tf-SI transponder key into the key slot on the Zedbull device.
  3. Select Transponder Clone Mode: On the Zedbull interface, select the cloning function. This mode allows the Zedbull to read the transponder’s unique data.
  4. Read the Transponder: Press the read button. The Zedbull will scan the original key’s transponder and display its data on the screen.
  5. Insert the Blank Key: Once the original key’s data has been read, replace it with the blank transponder key (make sure it’s compatible, such as a T5 chip transponder for the YM15Tf-SI).
  6. Write the Data: With the blank transponder in place, press the clone or write button. The Zedbull will transfer the data onto the blank key, effectively cloning it.
  7. Test the Key: Remove the newly programmed key and test it to ensure it starts the vehicle or performs the required function.
  8. Save Key Data (Optional): If your Zedbull software includes data storage, you can save the transponder data for future reference.

For the best results and further troubleshooting, consult the device manual or the software user guide, as additional settings may be needed depending on specific vehicle models. Make sure that the YM15T5-SI blank you are using is compatible with the T5 cloning protocol on your Zedbull V5z8, as some variations in key chip versions can impact compatibility.