4 or 6-Piece Window Insulation Set for 118″ Wheelbase Sprinter Vans (2002-2006) installation guide

Installation Instructions for 4 or 6-Piece Window Insulation Set

What You’ll Need:

  • Your window insulation panels
  • Velcro tabs (included in your kit)
  • Clean cloth or alcohol wipes (for surface prep)

Step 1: Prepare the Windows

  1. Clean the Surface:
    Use a clean cloth or alcohol wipes to thoroughly clean the interior edges of each window where the Velcro tabs will be applied.
    • Ensure the surface is free from dust, grease, or moisture for the best adhesion.
  2. Dry Completely:
    Allow the cleaned area to dry completely before proceeding.

Step 2: Attach the Velcro Tabs

  1. Locate the Velcro Tabs:
    Lay out the Velcro tabs included with your kit. Each insulation panel will have corresponding spots for these tabs.
  2. Apply the Velcro Tabs:
    • Peel off the adhesive backing from one Velcro tab.
    • Stick it firmly onto the cleaned window surface. Place tabs around the window frame at even intervals (corners and sides).
    • Press and hold each tab for about 30 seconds to ensure a secure bond.
  3. Repeat for All Windows:
    Continue attaching Velcro tabs to all windows that will have insulation panels installed.

Step 3: Attach the Insulation Panels

  1. Position the Panel:
    Align the corresponding insulation panel to the window. Each panel is custom-fit for a specific window, so double-check placement before securing.
  2. Secure the Panel:
    Press the insulation panel onto the Velcro tabs, ensuring a snug fit. Start from one side and work your way around, smoothing the edges to prevent gaps.

Step 4: Adjust and Fine-Tune

  1. Check for Fit:
    Ensure the panel covers the entire window with no exposed gaps. Adjust slightly if necessary by repositioning on the Velcro tabs.
  2. Test for Security:
    Gently tug on the panel to confirm it’s securely attached.

Step 5: Storing the Panels

  1. Remove for Storage:
    When not in use, simply peel the panels off the Velcro tabs.
  2. Roll and Strap:
    Roll the panels tightly and use the included straps to secure them for easy storage.
  3. Store in a Dry Place:
    Keep the rolled panels in a safe, dry location to preserve their condition.

Tips for Best Results:

  • Install the panels when the vehicle is at room temperature to ensure adhesive Velcro sticks effectively.
  • Recheck the adhesive Velcro tabs periodically, especially in high-temperature or humid conditions.
  • Clean the panels with a damp cloth if they accumulate dirt or dust over time.

Your insulation panels are now installed, providing enhanced temperature control, privacy, and security. Enjoy your improved van experience!